Add dump editor for VAG MED17, EDC17.(Component security bytes, PIN); Notes: 1. This version includes firmware 2 update. Please DO NOT disconnect PC.
Making modifications to the ECU road directions can become very harmful to your engine, so end up being very cautious.
A common transformation that individuals would like to create is to get rid of the Wear out Fuel Recirculation (EGR) function.
On Pre-PD engines it is definitely easy to perform mechanically by bIanking the EGR pipe off or just pushing the valve close and eliminating and shutting the vacuum cleaner tube that regulates the valve.
If you perform this on a PD engine you frequently get a problem code caution on the dash.
One way to remove the EGR functionality on a PD engine is definitely to empty it off (you can simply leave it shut) and remap the EGR chart in the écu.
Getting rid of EGR functionality by changing the map can still direct to a fault code becoming flagged. If that happens , alter the maximum configurations to about 95% of potential instead than 100%. That should avoid a problem program code.
CHANGING THE EGR MAP.This is definitely the greatest first switch to attempt.If it goes wrong, you are usually not most likely to harm the engine.
Hopefully you understand how to discover your EGR chart in Winols.It appears like this;
Click on the “EGR” chart on the major screen or click on the “EGR” name in “My routes”.
This will show the EGR map pop-up windowpane. It can be shown in 3D look at beneath.
It will probably open up in text view. If not, alter it to text view therefore it looks like this:
The text message view figures inform the ecu whát it should become informing the EGR valve to perform.
Look for the highest amount. In this case it can be 850. This “highest” quantity shows the EGR valve to remain shut.
You wish to change the entire map, therefore every amount will be 850. That method the EGR will stay close and not recirculate exhaust gases.
To modify the beliefs, click and move to emphasize them all.
E.g.
With the quantities highlighted, go to the toolbar, click on “Edit” followed by “modify absolute” (or just push the “=” key)